Maintenance Plans
Our skilled technicians offer a range of services, including drain cleaning, plumbing line installations, AC/furnace repairs, water heater maintenance, and water softener repairs. With over 15 years of experience, we are dedicated to delivering exceptional customer service across Lansing, MI, and guaranteeing your peace of mind. Contact us today to learn more about our maintenance plans and experience hassle-free plumbing and heating with Bartlett Plumbing and Heating.
Get Started Today
Preventative Maintenance
Dirt and neglect and the number one causes for heating and cooling failure. One of the easiest and most important steps you can take to prevent future problems is subscribing to biannual maintenance.
Our annual maintenance agreement evaluates the condition of the following:
- Thermostat calibration and operation
- Indoor air coil condition
- Clean air filter
- Electric heater controls and operation
- Relays and indoor unit wiring
- Indoor blower motor
- System general physical condition
- Indoor temperature rise/fall
- Outdoor fan blade balance
- Outdoor fan motor
- Contractor points
- Starting components
- Outdoor unit wiring
- Compressor amperage/performance
- Refrigerant charge
- Defrost components
- Reversing valve operation
- Ductwork
Summer Cooling 10 Point Service Check
- Install gauges and check operating pressure
- Clean condenser coil with water
- Check and tighten all electrical connections
- Lubricate bearings and motors where applicable
- Inspect and clear condensate drain
- Cycle and check thermostat for accuracy
- Check and adjust fan belt where applicable
- Check voltage and amperage to condensing unit
- Clean or change up to 2 basic air filters per system*
- Adjust charge to proper subcooling or superheat per factory specs, adding up to 1 pound of Freon at no additional charge
Winter Heating 10 Point Service Check
- Inspect heat exchange for cracks and soot
- Adjust flame for optimum efficiency
- Check fuel pipe and be sure of adequate draft
- Check and clean burners as necessary
- Check fuel supply for leaks and operating pressure
- Check and clean pilot assembly
- Check fan control and limit operation
- Check and lubricate blower assembly as necessary
- Cycle and check thermostat for accuracy
- Clean or change up to 2 basic air filters per system*
HVAC Maintenance Plan
The HVAC maintenance plan includes one furnace and one air conditioning inspection in a 12-month period. The cost is $180. A 10% discount applies on additional repairs and labor. If repairs are needed, you will be given a written quote on all repairs required. We offer a 100% satisfaction guarantee on all of our preventative maintenance agreements. Have peace of mind that your heating and air conditioning system is operating safely and efficiently.
Heating System Checklist
- Check burners and clean if necessary
- Oil bearings, unless sealed
- Check air flow
- Check all safety levels and calibration
- Check electrical connections
- Check temperature rise
- Check amperages and pressures
- Make necessary adjustments to controls dampers, valves and belts if applicable
- Flush condensate drain line
- Check the ductwork
- Check blower motor and wheel
- Inspect heat exchanger for cracks or damage
- Clean/change filter*
- Perform carbon monoxide test
AC Checklist
- Check refrigerant charge
- Check compressor amperage
- Check condenser fan amperage
- Check electrical connections
- Check contactor ponts
- Check the capacitor
- Check thermostat level and calibration
- Check condensing temperature split at condenser
- Flush condensate drain line
- Change or wash your filter*
get in touch with us at 517-925-8205.
Bartlett Plumbing and Heating
Business Hours:
8:00 AM to 4:00 PM
Contact
Phone: 517-925-8205
Email: emily@bartlettplumbingheating.com